{"id":2475,"date":"2019-10-24T15:45:45","date_gmt":"2019-10-24T19:45:45","guid":{"rendered":"https:\/\/www2.whoi.edu\/site\/itp\/?page_id=2475"},"modified":"2021-07-20T13:26:48","modified_gmt":"2021-07-20T17:26:48","slug":"itp54-data-processing","status":"publish","type":"page","link":"https:\/\/www2.whoi.edu\/site\/itp\/data\/completed-missions\/itp54\/itp54-data-processing\/","title":{"rendered":"ITP 054 Data Processing"},"content":{"rendered":"\r\n\t<h1>ITP54 Data Processing<\/h1>\r\n\t<p>Out of the 1055 profiles that were apparently performed by the ITP profiler, software problems with the inductive modem circuit prevented all except for 106 of the CTD profiles from being received by the surface package which were subsequently telemetered. \u00a0These were processed according to the procedures described in the\u00a0<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/08\/ITP_Data_Processing_Procedures_35803-1.pdf\">ITP Updated Data Processing Procedures<\/a>.\u00a0 The processing parameters for are shown in the figures to the right.\u00a0 Of the profiles communicated to the surface package, buoy drift speeds were almost always less than 30 cm\/s so the profiler covered close to the full vertical extent except for a few profiles.<i>\u00a0\u00a0<\/i><\/p>\r\n<p>This particular ITP was the first outfit with the newer IMM hardware rather than the SIM\/UIM configuration of earlier units in order to allow a Microcat to be added to the tether at a fixed depth and that higher temporal resolution (15 minute) T&amp;S data to also be communicated to the surface package on the same circuit.\u00a0 However, in this prototype the shorter engineering files were able to be conveyed to the surface unit, but the longer CTD files often timed out before being successfully sent.\u00a0 Consequently, the 106 CTD profiles received were within the first 230 profiles that the profiler conducted, but were not all consecutive and included gaps. Thermohaline staircases were present during the time series, enabling CTD lag correction estimates.\u00a0 The lags started in typical ranges but drifted, particularly after profile 163.<\/p>\r\n<p>Communications between the surface unit and Microcat were better, and all samples were received for the first 170 days (until January 23, 2012).\u00a0 Then there was a gap of over 225 days (until June 5, 2012) until the next samples from the Microcat were received by the surface package.\u00a0 Subsequent gaps occurred between July 12, 2013 and September 8, 2013 (58 days), September 16, 2013 and June 15, 2014 (272 days), and June 23, 2014 and June 25, 2014 (1 day).\u00a0 The last Microcat data were acquired on July 5, 2014. \u00a0No corrections have been applied to the Microcat T&amp;S data.<\/p>\r\n<p>See the Data Products tab to the left for descriptions of the three levels (I, II, III) of data processing and to access all data.<\/p>\r\n\t\t\t\t<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54loc2_456016.jpg\" target=\"_self\" rel=\"noopener noreferrer\">\r\n\t\t\t\t<img loading=\"lazy\" src=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54loc2_456016.jpg\" alt=\"ITP Surface Buoy Status.\" height=\"1730\" width=\"1000\" title=\"itp54loc2_456016\" \/>\r\n\t\t\t\t<\/a>\r\n\t\tITP Surface Buoy Status.\r\n\t\t\t\t<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54dat1_456039.jpg\" target=\"_self\" rel=\"noopener noreferrer\">\r\n\t\t\t\t<img loading=\"lazy\" src=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54dat1_456039.jpg\" alt=\"ITP profiler engineering data.\" height=\"1480\" width=\"1560\" title=\"itp54dat1_456039\" \/>\r\n\t\t\t\t<\/a>\r\n\t\tITP profiler engineering data.\r\n\t\t\t\t<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final1_456059.jpg\" target=\"_self\" rel=\"noopener noreferrer\">\r\n\t\t\t\t<img loading=\"lazy\" src=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final1_456059.jpg\" alt=\"Top: number of bad points removed, Middle: variance of verticle difference of temperature and salinity in step region for up-going profiles, Bottom: temperature lag.\" height=\"2735\" width=\"2047\" title=\"itp54final1_456059\" \/>\r\n\t\t\t\t<\/a>\r\n\t\tTop: number of bad points removed, Middle: variance of verticle difference of temperature and salinity in step region for up-going profiles, Bottom: temperature lag.\r\n\t\t\t\t<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final2_456018.jpg\" target=\"_self\" rel=\"noopener noreferrer\">\r\n\t\t\t\t<img loading=\"lazy\" src=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final2_456018.jpg\" alt=\"Top: conductivity lag, Middle: conductivity thermal mass amplitude correction, Bottom: conductivity thermal mass lag correction.\" height=\"2728\" width=\"2005\" title=\"itp54final2_456018\" \/>\r\n\t\t\t\t<\/a>\r\n\t\tTop: conductivity lag, Middle: conductivity thermal mass amplitude correction, Bottom: conductivity thermal mass lag correction.\r\n\t\t\t\t<a href=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final3_456041.jpg\" target=\"_self\" rel=\"noopener noreferrer\">\r\n\t\t\t\t<img loading=\"lazy\" src=\"https:\/\/www2.whoi.edu\/site\/itp\/wp-content\/uploads\/sites\/92\/2019\/10\/itp54final3_456041.jpg\" alt=\"Top: down pressure deviation correction, Middle: salinity ratio adjustment, Bottom: Number of filtered spikes.\" height=\"2724\" width=\"2028\" title=\"itp54final3_456041\" \/>\r\n\t\t\t\t<\/a>\r\n\t\tTop: down pressure deviation correction, Middle: salinity ratio adjustment, Bottom: Number of filtered spikes.\r\n","protected":false},"excerpt":{"rendered":"<p>ITP54 Data Processing Out of the 1055 profiles that were apparently performed by the ITP profiler, software problems with the inductive modem circuit prevented all except for 106 of the CTD profiles from being received by the surface package which were subsequently telemetered. \u00a0These were processed according to the procedures described in the\u00a0ITP Updated Data&hellip;<\/p>\n","protected":false},"author":83,"featured_media":0,"parent":2455,"menu_order":2,"comment_status":"closed","ping_status":"closed","template":"tpl-sidebar.php","meta":{"advanced-sidebar-menu\/link-title":"","advanced-sidebar-menu\/exclude-page":false},"_links":{"self":[{"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/pages\/2475"}],"collection":[{"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/pages"}],"about":[{"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/types\/page"}],"author":[{"embeddable":true,"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/users\/83"}],"replies":[{"embeddable":true,"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/comments?post=2475"}],"version-history":[{"count":3,"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/pages\/2475\/revisions"}],"predecessor-version":[{"id":3606,"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/pages\/2475\/revisions\/3606"}],"up":[{"embeddable":true,"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/pages\/2455"}],"wp:attachment":[{"href":"https:\/\/www2.whoi.edu\/site\/itp\/wp-json\/wp\/v2\/media?parent=2475"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}